The image below requires the Whip!
driver from Autodesk to be installed.
Click to install the driver now.
Once installed, you may zoom, pan, plot or save this
detail by clicking on the right mouse button to active the menu.
You may also drag and drop it into an AutoCAD
drawing. To do this, hold down the CONTROL key while dragging and drop it into
AutoCAD R14 via the INSERT command, or hold down both the SHIFT and CONTROL keys to
perform an OPEN command.
INSTALLATION INSTRUCTIONS FOR LOW VOLTAGE WELL LIGHTS
FOR USE ONLY WITH LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT
EXCEED 25 AMPS, 15 VOLT MAX.
WARNING: Fixture must be
installed in accordance with local codes of the National Electrical Code (NEC).
Failure to do so may result in serious injury and/or damage to the fixture.
SAFETY WARNING: Fixture can become very hot depending upon the lamp
wattage used. Lens and metal around the lamp can become hot enough to blister
hands. Particular care should be take no to locate fixtures where small children can
reach them if high wattage lamps are used.
LUMINARIES ARE NOT TO BE INSTALLED WITHIN 10 FT. (3.05 M) OF A POOL OR SPA.
TOOLS REQUIRED FOR INSTALLATION:
Flat Blade Screwdriver
Wire Stripper
Silicone Grease
PRECAUTION: Fixture is not submersible and adequate drainage must be
provided during installation. It is recommended that the fisture be surrounded by
3" to 4" of pea gravel to assure proper drainage. Top of fixture must be
above grade so rain and irrigation water cannot accumulate for long periods of time (see
figure).
To prevent electrical shock, disconnect transformer from electrical supply before
installation or service.
With flat blade screwdriver, loosen terminal screws located on the back of the PAR-36
lamp (see figure).
Connect lamp holder leads (blue spade connector) to lamp terminals and tighten screws
(see figure).
Coat screws with silicone grease.
Install lamp into black silicone rubber lamp holder (see figure).
Dig hole to appropriate depth allowing 3" to 4" of pea gravel to surround ABS
sleeve (see figure). NOTE: ABS sleeve is reversible. Straight cut end allows flush
ground mounting and an optional grate cover (which may be ordered sperately but is not
required). Angle cut end requires the top three (3) inches to be installed above ground
for vertical aiming.
Place fixture with service bracket inside ABS sleeve and adjust angle.
Run wire pigtail through bottom of ABS sleeve and strip the two (2) leads from the
fixture wire. Using the two (2) silicone filled safety connectors (supplied) connect
the leads from the fixture to the main supply cable leads (see figure). NOTE: Fixtures are supplied with 36" of 18-2 cable pigtail for
secure connection to the main supply cable. Always coil extra cable not used below
fixture for future relocation if desired. NOTE: There are two (2) knockouts on the bottom of the rubber lamp holder
which should be removed to provide proper ventilation for lamp and for drainage of any
water which may seep in. Removing knockouts and providing proper ventilation will
prolong the life of the lamp (see figure).
IMPORTANT SAFETY INSTRUCTIONS:
LIGHTED LAMP IS HOT!!
WARNING: TO REDUCE THE RISK OF FIRE, OR INJURY TO PERSONS:
Turn off / unplug and allow to cool before replacing lamp.
Lamps get HOT quickly! Contact only switch/plug when turning on.
Do not touch hot lens, guard or enclosures.
Keep lamp away from materials that may burn.
Do not touch the lamp at any time. Use a soft cloth. Oil from skin
may damage lamp.
Do not operate luminare fitting with a missing or damaged shield (cover).
SAVE THESE INSTRUCTIONS
LAMP INSTALLATION / REPLACEMENT:
CAUTION: Do not exceed maximum wattage marked on fixture label.
to install the driver now.